WASTE REDUCTION AT PT. X WITH LEAN MANUFACTURING APPROACH

Angelio Pratama Ramadhan, Lisa Ratnasari, Kohar Sulistyadi

Abstrak


In 2020 PT. X produces approximately 220 thousand packaging, this causes the paper raw materials used to exceed the maximum limit or exceed the insheet determined by the company. So that there is a loss to the company, both in terms of material and time. There are 3 types of waste or damaged products that are most dominantly found using lean manufacturing methods. The three  most dominant wastes are excess insheet, non-standard color and excess glue. The application of lean manufacturing is expected to reduce waste in 2020 and maximize the profits obtained. In implementing lean manufacturing, it is supported by using value stream mapping methods  and process activity mapping which is expected to get factors that cause waste. Waste that occurred in 2020 averaged 7.82%, greater than the standard set by the company with an average of 5%.


Kata Kunci


Lean Manufacturing; Process Activity Mapping (PAM); Value Stream Mapping (VSM)

Teks Lengkap:

PDF


DOI:

https://doi.org/10.36441/seoi.v5i2.1911

Article Metrics

Abstrak views : 97 times
PDF views : 71 times

Dimension Citation Metrics

Refbacks

  • Saat ini tidak ada refbacks.


Copyright (c) 2023 Sustainable Environmental and Optimizing Industry Journal

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

Sustainable Environmental and Optimizing Industry Journal Terindeks di:

width=width=width=width= width=

 

 

Lisensi Creative Commons Ciptaan disebarluaskan di bawah Lisensi Creative Commons Atribusi 4.0 Internasional.

 

View My Stats